|
Tractor Talk Discussion Board |
Re: Swather; 'Nother Dumb Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KEH on June 20, 2005 at 18:14:20 from (64.53.73.55):
In Reply to: Swather; 'Nother Dumb Question posted by Allan in NE on June 20, 2005 at 11:46:53:
Allan,
Don't know about your Haybine, so I wont add anything except to say be careful about putting too much weight on the back of the truck and getting the front end light.
I was struck by your remark about crossing open range. Don't guess you mean the old time open range. That reminds me of a story. About 1971 the wife and I took a trip to the Grand Canyon and not too far out of Flagstaff on hwy 180 we saw signs warning of open range. Seems the cows had the right of way. At the intersection of 180 and 64 there was an attempted real estate development, few roads cut through the brush. About 15 years later wife and I and 2 girls took another trip through there. A few roads still in the brush, a trailer or two, a campground, and a filling station where the owner tried to sell me $140 air shocks because the station wagon was loaded down, sorta like the Beverly Hillbillies car. I said no thanks, drove car another 100k miles, no new shocks. Turned out the place hadn't developed because there was no water, had to truck in water from Flagstaff. Couple of people had drilled 5000 foot dry holes. Volcanic soil there wont hold rainfall. Oh well, good luck on the drive. Liked your Green grain drill. Hope I don't double post this time. KEH
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
