Tractor Talk Discussion Board |
Re: Help, Ford 3600, Removing Lift Cover
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RickB on June 25, 2005 at 12:57:38 from (205.231.146.217):
In Reply to: Help, Ford 3600, Removing Lift Cover posted by Kirk Grau on June 25, 2005 at 10:38:45:
The cylinder safety valve extends under the web at the front of the rear axle center housing. There is also a jumper tube that supplies oil to the lift cover from the center housing located just aft of the right front corner of the cover. Raise the cover up a little, get on the tube with pliers or needle nose ViseGrips and wiggle it back down into the center housing until it releases from the hitch cover. Then lift the cover up and back leaving the front down until the safety valve clears the web in the center housing. hope you are using a hoist. Trying to lift the cover off by hand alone won't work out well.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|