Tractor Talk Discussion Board |
Re: Fought Me All The Way
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on July 19, 2005 at 07:01:28 from (148.78.243.26):
In Reply to: Re: Fought Me All The Way posted by txgrn on July 19, 2005 at 06:42:19:
Yes and No, Took the tire and wheel off. Set the front end on some short 3' cut off railroad ties with the other tire on the ground. Tied the chain tight up around the upright on the tube both top and bottom. Then, I just gave it a couple of "little jerks". The whole 966 wanted to move on me and if it wouldn't have came, I would have taken another tractor and anchored the other side grabbing the outer tube. Luckily, I didn't have to get quite that extreme because the thing had been soaking for three days. Every few minutes I would dose it with another shot of PB Blaster. I used a whole can and ran out; so then started using plain old diesel fuel. The diesel fuel really seemed to do a better job, I thought. You should have saw the crap that came out of that tube! The tie rod, since it had been soaking for so long, came right out. Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|