Tractor Talk Discussion Board |
Re: Why narrow front tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on July 28, 2005 at 13:41:31 from (216.183.136.2):
In Reply to: Re: Why narrow front tractors posted by txgrn on July 28, 2005 at 07:11:47:
I would have to agree that narrow front tractors don't get driven into as tippy situations that a wide front gets driven into. I should get a couple of the kids toy tractors and tip them sideways and angle ways on a board. To see if the wide or narrow front is more stable.My bet says the wide front will stay upright a couple of degrees farther than a narrow. It takes only bumpy ground at modest speeds on a moderate side hill to roll any tractor. A narrow front tractor may have had the rear wheels set narrow for rowcrop use. The wide front tractor may have a wider stance and be more stable. Because the wheels are set right out flush to the ends of the axle from the factory. Not too many people go through the work of regularly changing rear tread widths. Around here the collectable narrow fronts are all set with the rear wheels out flush to the axle ends. At some shows I've seen narrow front row crops with the rear wheels set as narrow as possible. The sides of the tires are "almost rubbing the operator's foot rests". They look like a couple of kids could tip them over with a good push.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|