Tractor Talk Discussion Board |
shortening PTO shaft with zerk fittings
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB OH on July 29, 2005 at 08:53:29 from (206.183.9.18):
I have a '63 Ford 2000 to which I just added an over running clutch, but the PTO shaft is now too long for my bushhog. My understanding is that I have to shorten the PTO shaft to accommodate the ORC (by about 4" or so?). Here's my dilemma: The PTO shaft has a grease (zerk) fitting approximately 2" from the open female end of the shaft, with another zerk another 4" down from the first. Cutting the shaft at 4" from the end will sacrifice at least the first zerk, and leave the second one about 2" from the end. There may be some sort of seal or something as well, because the shaft has a "pinch" or 1/8" thinning of the diameter surrounding the pair of zerks. I don't know if this is typical, or if there is some other purpose I'm unaware of, other than greasing the extending shaft. Should I just cut the shaft and leave the one zerk remaining, or is the "pinch" surrounding the two zerks doing something I should be concerned about?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|