Tractor Talk Discussion Board |
Re: Bumper Hitch vs. 5th Wheel/Gooseneck
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on September 25, 2005 at 13:57:02 from (4.240.90.105):
In Reply to: Bumper Hitch vs. 5th Wheel/Gooseneck posted by Glenn F. on September 24, 2005 at 17:42:13:
Hi Glenn, The problem with a tag trailer (bumper puller) is there's only so much tongue weight(TW) you can have as the hitching has weight restrictions. I built a a custom receiver/hitching to where I was stable at any TW upto 4k pounds but then the weakest link was the 3/4" hitch pin, needed to be 1" or more. Even with custom hitching I could see acellerated wear on my hitching while pulling the heavier trailer weights, 20kGVW so it was time to move into a GN before I tore something up. In 40yrs of pulling trailers I never used WD or anti-sway devices other than to try them out. I never had a need for them as my tow vehicle was always more than my trailer required and my load weights were always placed evenly on the trailer deck. The main difference between a 5th/GN comparred to a tag, is you can distribute the load weight more evenly over a longer pin to axle center line. The longer the pin to axle center line is the better the trailer pulls as it's more stable. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|