Tractor Talk Discussion Board |
Re: 9N voltage regulator...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dell (WA) on October 07, 2005 at 10:06:19 from (172.193.195.77):
In Reply to: Re: 9N voltage regulator... posted by John T on October 06, 2005 at 06:32:07:
John.........yes to yer question #1. BOTH the 1939 N9 and the 1942 2N use the same 3rd brush genny and 2-terminal roundcan cutt-outt relay scheme. The 1948 8N uses a 3-terminal shunt-wound genny with a 4-wire (BATT, ARM, FLD, GND) "viberating field relay" squarecan voltage regulator in a "class A" genny charge configuration. While one of the genny to VR wires is a "ground" wire, it is NOT a control wire but provides low resistance ground between the genny barrel and the VR frame for voltage reference. The speed of the vibrating field relay is dependent upon the battery volts and controls the current thru the genny field and consequently the magnetic field strengh which controls the genny AMPS output. It also has a polarity sensitive cutt-outt relay and 2-relay cores. The 1953 NAA Jubilee and onward was changed to the "class B" genny charge configuration.........Hope this helps..........Dell, 40yrs Electronics Engr, ret Boeing Flt Test Engr
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|