|
Tractor Talk Discussion Board |
Re: Will straight pipe hurt motors??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark - IN. on October 14, 2005 at 05:13:29 from (205.188.117.6):
In Reply to: Will straight pipe hurt motors?? posted by logan on October 13, 2005 at 19:54:20:
Yes, no, and maybe. First off, it's not back pressure that prevents valves from floating, it's spring pressure. The weaker the spring, the better the chances of valves floating at higher RPMs. The stronger the spring, the less chance, but the more wear and tear on the rest of the valve train (cam lobes, fulcroms, etc). Back pressure actually keeps the face and back of the valve at a more even temperature, which lack of can cause failure. Too little back pressure over time and will notice damage caused because the face of the valve is typically hotter than the backside exhausting the burnt gases into a cooler manifold, header runner, etc. As far as adding horse power, that can be true under the right conditions. Runner length and diameter directly affect both horse power and torgue. I can't count the number of times I've seen headers or open exhaust on an engine show a decrease of either horse power, torque, or both because the diameters were too large, the lengths were too short, or too long, or a combination of both. Chances are you're going to want to run a longer pipe because your engine is a lower RPM engine, and torque is what you're after. Is your engine normally aspirated? Turbo charged? What's your cam lift? It's duration? Straight pipes can be good, under the right conditions. They can be just as bad if aren't tuned to the needs of the engine, which should be tuned to your needs. The answer to your question as posed is yes, no, and maybe. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
