Tractor Talk Discussion Board |
Re: A non-corrosive tire fluid?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on November 24, 2005 at 01:52:48 from (216.208.58.104):
In Reply to: A non-corrosive tire fluid? posted by in-too-deep on November 23, 2005 at 07:59:49:
To start with calcium chloride has never been a problem for most commercial farmers. They wore a set of tires out in 5-7 years, pumped the chloride out, installed new tires and new stems on the tubes and pumped the chlorde back in. Most cleaned the rims and painted them each time. The problem with chloride started when folks began low hour per year, use of older tractors. With that tires were on tractors 20 years and longer. Most of the leaks doing damage to rims have been caused by one type of leak, that being valve stem leak. The cure for this is plain good maintainence. If you are in this last catergory, about every 5-7 years, park the tractor with valve stem at top. Jack the tractor to take weight off tire. Remove and replace the center screw in stem, then re inflate the tire. Another maintainence item done by farmers was in the event of a tire puncture, you cleaned the rim up and repainted it before re installing. Plain and simple guys, with good maintainence chloride will never destroy rims. I know of tractors over 50 years old original rims and have had chloride since new. Most rim rust outs have been caused by tractors going for years with leaky valve stems. Small pin holes in tubes very quickly become flat tires.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|