Tractor Talk Discussion Board |
Re: Weigh scales
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by john in la on December 08, 2005 at 18:57:36 from (68.222.11.156):
In Reply to: Weigh scales posted by Jerry Bliler on December 08, 2005 at 08:21:07:
While you most likely do not need to stop because it is a household move; stopping so you can avoid the harassment is OK. Most trucks do not like to stop at the scales because of the DOT. Since you have no log book; are not responsible for any infractions for faulty equipment; you will only be worried about weight. This is why you should not let the scales scare you. Any DOT violations are the truck owners problem not yours. Once you have your truck loaded and ready to leave stop at the local truck stop and weigh the truck. Will cost you about $8. You will be allowed 12,000lbs on the steer axle and 20,000lbs on the drive axle in all states. (some allow more) Once you know the weight is correct you are ready to go. As you approach the scale notice any signs that may tell you to bypass. Some states weigh with a motion scale in the road and then flash a sign telling you to bypass if OK. When you pull onto the scale ramp you will line up with other trucks. Some states weigh each axle one at a time and some states have 3 scales in a row that weigh the whole truck at one time. Notice what one they have. There will be a sign next to the scale. It will have words............ STOP NEXT AXLE or PULL UP BACKUP GO AHEAD REPORT INSIDE Just follow the signs. Once the truck in front of you has cleared the scale you will pull forward onto the scale. Stop with your front axle on the 1st or only scale depending if it is a single or whole truck scale. Once you are weighed you will get a Go ahead or Report inside sign. If it says report inside pull to the side and walk inside.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|