|
Tractor Talk Discussion Board |
8N Won't Run
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gary Hopper on December 12, 2005 at 18:26:59 from (64.85.217.94):
Bought an 8n that hadn't started for 2 years, after it had a carburator kit put in. Found the needle valve spring in upside down, thought it was fixed, it wasn't. It will start and run with a leakage tester plugged in where the coil wire goes into the distributor, this throws a continuous spark which fires as the rotor turns, and bypasses the ignition system. Replaced the condenser, and tractor started and ran on it's own for several times one afternoon, then died and is back like it was. Getting gas, spark looks good, timing and compression are good, tried distributor cap and points, nothing helps. Haven't tried plugs and wires yet, but guess I will, but seems like they should be good, since it will run on leakage tester. Any ideas? I'm stumped.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
