Tractor Talk Discussion Board |
Re: OT traction ballast how much weight in pick-up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jonfarmer on December 14, 2005 at 10:44:08 from (165.121.145.136):
In Reply to: OT traction ballast how much weight in pick-up posted by Tim B From MA on December 14, 2005 at 10:07:06:
Lots of folks around here use round bales for weight. Works good, but does block your rear view of course, but it's about the cheapest unless you get some bags and fill them full of sand, others use cement blocks. Scrap yards don't pay a heck of a lot for scrap steel, but if you want a piece they'll charge you an arm and a leg for it, so using 400-500lbs of scrap steel from a scrap yard is going to hit your wallet quite hard, V.s buying a round bale off someone for $20. Some people just shovel alittle sand in the back of their trucks, but I wouldn't reccomend doing that as the sand is going to get wet and stay wet which will rust your box out. HTH!
Replies:
Home
| Forums
Today's Featured Article -
A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|