Tractor Talk Discussion Board |
Re: Water Well Problems 2
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bus Driver on December 25, 2005 at 16:54:58 from (66.226.36.217):
In Reply to: Water Well Problems 2 posted by john in la on December 25, 2005 at 06:56:11:
Something is missing here. If this well is truly 2" diameter and as deep as you say, then a two pipe system is the only thing that will work with a jet pump. For 2" wells, the pipes are concentric and the space between the inner pipe and the well casing is the second pipe. The jet seals against the casing at the bottom and there is sealing cap at the top where the second pipe to the pump is attached. The seal at the bottom is expandable and the pipe is turned to expand or contract the seal. Better get an expert in this type setup to check yours. Your sketch does not match my description, so I may be wrong. I know of no submersible pump for 2" wells.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|