Tractor Talk Discussion Board |
Re: Threaded Aluminium
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by doogdoog on January 13, 2006 at 14:36:25 from (72.132.200.132):
In Reply to: Threaded Aluminium posted by Ken Biggs on January 13, 2006 at 07:30:30:
Aloha, If I am reading your post right, it looks like you are referring to the engine block thread?? If there is enough clearance, I would get a threaded rod the same size as the bolt and thread it into the block until it bottoms out. Thread two nuts on the end of the rod and lock it. Try turning it with a wrench until it won"t go anymore and do this with the bracket on. Mark it so it will have enough threads for the two nuts after you cut the rod. Put the two nuts back on the end of the rod and screw it back into the hole and you may use some locktite to keep it tight. Remove one nut and secure the other nut and don"t forget the lock washer. This usually works unless the threaded hole is worn out.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|