Tractor Talk Discussion Board |
Re: is a 2 cylinder enough power for a car?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by davpal on March 26, 2006 at 16:10:41 from (216.93.88.212):
In Reply to: is a 2 cylinder enough power for a car? posted by projectman65 on March 24, 2006 at 10:07:47:
My question would be why would you want to do this? I have a lincoln mark 8 that has 280 horsepower and gets 25 miles per gallon, about 2.4 gallons per hour at 60 mph. I also have a zero radious toro mower that has a 23 horsepower kohler, similar to your briggs that uses a lot of fuel just to run a 52 inch mower deck and mower around. You are not going to gain any benefit other than having a car that is a loud noisy unreliable nightmare and a big liabiltiy on the highway I might add. If you are dead set on mileage get a four cylinder gm motor and put in there and strip all the unecessary weight out of the car or better yet find a three or four cylinder small diesel engine and convert it over to that.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|