Tractor Talk Discussion Board |
Re: Colorado Curt or Somebody.....HELP!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by evielboweviel on April 01, 2006 at 07:33:50 from (65.24.181.184):
In Reply to: Re: Colorado Curt or Somebody.....HELP! posted by Princeton bill on April 01, 2006 at 06:25:03:
last september I plowed 22 acres with my 1650 and a white 4-16 semimounted plow. This ground went into government ground around 1984 and two small patches (5 acres) had been in hay since 1981. Then was hay ground every year. Last five years just got hogged off. It was extremely dry and very hard where a gas line repair crew had driven on it in the spring when it was wet. Plowed in 2cd under at 2400 rpm started out in 2cd direct and blew a head gasket was running warm so slowed down and plowed before daylight to noon. ran 10" deep and did good in it except the section where the pipe line repair crew drove at. Going east could plow it by ramming the throttle against the stop and picking the plow up about 2 inches it was rolling boulders out. Going west the plow popped on top of the ground and slid across the tracks then went back in. Back tires loaded one weight on each side starter and two slabs on the front. When plowing the last couple of rounds against the fence was in 1st with the front end up by every tree plowing out roots and sometimes had to push the clutch in or flip over. Central Ohio did get rain on it so we could work the ground up and plant wheat. Want to plow it again this year and then should be able to just disk for a few years. will be wheat each year. Ron
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|