Tractor Talk Discussion Board |
Re: Farmall F-20
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by josh in indiana on February 07, 2006 at 21:27:09 from (12.208.56.205):
In Reply to: Farmall F-20 posted by ChuckIH on February 07, 2006 at 18:38:50:
Chuck, Is the mag impulse making a good strong snap as you roll it over? If it isn"t then I would suspect mag problems. Also, did you file the points? Those old up draft carbs can be a real bear to get fully primed. On my 20 I usually have to pull it to start it when i try it for the first time after winter. It sometimes takes a fair amout of pulling too. Gas can be leaking out and I will still have to do this. Sometimes its just the nature of the beast. The Nebraskacowman is very knowlegable about thos F20"s and he ca help ya out lots. Good Luck Josh in Indiana
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|