Elmer or Barry - I have 3 point problems

Posted by TOOLTIME on February 13, 2006 at 16:37:30 from (4.229.99.59):

Hi Guys,

My db 990 diesel 3 point won't lower either. I read Barry's message and will check it out. My push rod guide (behind the control levers) is broken inside the casing and the push rod spring and clip keep falling off. Where could I get a good pushrod guide and pushrod with spring and clip?

I looked in at the RH 2 screw cover plate and the oil only oozs from the end of the valve spool when I try to lower it. It won't move.

The flexible control cable has a twisted strand, but still works somewhat freely. Could that be a problem too? My draft control lever is broken off, but I didn't think that would prevent it from working.

Finally, the control levers don't hold in place and it appears the amount of movement is very, very small compared to a ford 8N.

Thanks,
mark

Replies:

• Re: Elmer or Barry - I have 3 point problems cj3b_jeep 05:13:36 02/14/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]