Tractor Talk Discussion Board |
Re: Has any one ever tried
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by `Bernie in MA on April 06, 2006 at 15:25:21 from (140.186.103.69):
In Reply to: Has any one ever tried posted by old on April 06, 2006 at 08:18:30:
I've freed up stuck valves in Wisconsin engines many times by putting the short end of an allen wrench thru the sparkplug hole and rotating it until it's over the valve, then tapping it down with a small hammer. Take the wrench out, turn the flywheel til it sticks up again and repeat. Make sure it isn't where the cam is holding it up. When it snaps back down with just a tap you're almost there. Use Kroil or your favorite juice while doing it.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|