Tractor Talk Discussion Board |
Dumbest Man In My Shoes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on April 14, 2006 at 14:35:46 from (148.78.243.25):
Brother! Sometimes, I'm so darn dumb that I think I need to be locked away. :>( I've always had this heating problem with my 686 after it pulls for an hour or so; couldn't figure the darned thing out. Didn't "seem" to be getting hot, but it just makes me nervous that it "says" it is hot. Yesterday, when the gauge got up to the "hot" mark, I stick the bulb of a new gauge in the radiator and the new gauge says the temperature is just fine. Okay, I've found the probelm, right? It's the gauge. Was telling the guys over on the Farmall board about it and one of the guys says, no that the thermostat is not opening far enough. Now, I'm worrying. Don't wanna hurt that engine. So, I spent an hour pulling sheet metal, etc off the tractor to gain access to the silly thermostat 'cause it is not all that easy on a 310. I've got her stripped completely down and find this in the picture. Little washer is totally blocking the water flow under the thermostat. Anyway, 2 hours total spent putting in the new thermostat and buttoning 'er back up. NOW, I'VE GOT IT! No sense putting that new gauge in, right? I'VE FINALLY FOUND THE PROBLEM! Dumb idea. I head fer the field and I should have replaced the gauge while I had her stripped down as well. After an hour of pulling, temperature is now reading "just off hot" so both items were bad and now I've got to strip her all back down again to put the gauge in too. Some days get long by default around my house. :>( Allan
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|