Tractor Talk Discussion Board |
Re: rebuilding edge of mower blades with weld
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jeffcat on April 26, 2006 at 12:14:09 from (216.107.36.172):
In Reply to: rebuilding edge of mower blades with weld posted by ironhoarder on April 26, 2006 at 07:48:32:
A little off the mark but very close. About 1983 I made a set of "Hard" blades for my Dad's John Deere 110. Bought that blue color rod from the local weld supply. Comes in a pack of maybe 10 rods and it is VERY hard after it cools. I ground the edge square and matched both blades with a mechanic ruller and by weight on a blade balance. Do like you did with several layers till you get a nice layer on the edge. Found the stuff is so hard that the 4 1/2 inch grinder will not make sparks! What a pain-but what an edge! It will stay razor sharp for several mowings and your grass looks real good. If you hit a stone "driveway stuff" you will make a chip in the edge. Just reweld when you finally get around to it. With "brush hog" type units you must be very careful as how you balance them. I did some very careful measures and ground them to the same dimensions. Weigh them with a balance you can make. Piece of 2x4 with the blade on the end and a fulcrum. Use the other blade as the weight. If you can change them side to side you got it. Keep it simple stupid-KISS and it is no sweat. I was very happy with those blades but boy do they take a lot of work!. Have fun. Jeffcat PS You can get a lot of new blades from Tractor supply Etc. Might be cheeper?
Replies:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|