|
Tractor Talk Discussion Board |
New Fence FINALLY done
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dachshund on June 19, 2006 at 11:47:37 from (71.31.166.227):
It takes me FOREVER to build fence (due to knees, back, hip, etc, etc,), but I FINALLY finished this section! I put up close to 1100' of woven wire fabric, planted 21 Wood posts, and drove another 32 steel posts. Built 4 corners and 2 pulls, crossed a small creek, and tangled with Posion Ivy. It's a little over 1.25 acres. I had existing fence on one side and part of another, but had to cover it with woven wire for the goats. I scrounged the wire, cut the wood posts from trees in the pasture, cobbed onto the 4 gate posts (they are actually old bridge piers - big and HEAVY), and managed to scrounge the steel posts and gate as well. I spent $12 on staples and clips (have some left over, too!), so I figure the Poison Ivy on my hand is worth it! I managed to get a couple of posts turned the wrong way so the bend in the post is out instead of with the fenceline, but I can cut the tops off a bit and it will be less noticable. Took me over a month, but the goats are happy with all the goodies that are available to munch! I will probably wait a bit before I start on another stretch I need to do! This is about 450' along my driveway. I AM looking for volunteers to come to SE Nebraska and help cut posts and plant them.........
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
