Tractor Talk Discussion Board |
Re: O/T temp grazing-hay
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Glen in TX on June 23, 2006 at 10:27:10 from (208.246.9.225):
In Reply to: O/T temp grazing-hay posted by BigMarv1085 on June 23, 2006 at 10:00:14:
Yes, want to be careful on nitrate poisoning levels for stressed milo, sorghum-sudan cross haygrazers, hegari (hi-gear), millets and silage sorghums. Not sure if millets are as bad about holding nitrates as the others?? I'm not remembering what the acceptable levels are now right off hand but you need to take some samples to a test lab before grazing or haying it especially in a droughty condition. They should be able to advise you on safe levels. Do more than one spot sample from each field as it can vary a lot too. I've seen some cut and bale milo or sorghum grazers stressed out after a freeze even but nitrate levels were way too high before the freeze and later in winter the hay killed cattle. You also need to be able to fence cattle off of it when a freeze hits for 2 weeks or more till it drys down and nitrate levels go back down. We had bad nitrate problems a few years ago and some found out after spending the money to bale it nitrates were too high and not wanting to chance others cattle getting in the hay before or if levels went down they had to burn the hay to destroy it. Buckwheat isn't grown here so I don't know. County extension agent and local animal nutritionist in your county should be able to provide help also.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|