Tractor Talk Discussion Board |
Re: Seeking Trailer Building Advice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEH on July 24, 2006 at 12:09:01 from (209.213.23.31):
In Reply to: Re: Seeking Trailer Building Advice posted by Buzzman72 on July 24, 2006 at 08:54:18:
I have built some trailers and hauled square bales in my younger days before I got a round baler. Some observations: You did not say what size tires you will be using. If you are using the 8.00 x 14.5 lowboy tires they will carry the hay you are likely to put on it. When I was hauling square bales, I wanted the trailer to be as close to the ground as possible. If you build an 8 ft. wide bed above the wheels it will be higher to throw the bales up but if you have 2 people working it won't be as much of a problem and the extra capacity will make up for the inconvenience. I think if you add a dovetail to the back it will take too much weight off the tongue making it pull badly. When hauling hay on rough ground a dovetail might drag the ground also. I have this problem on a gooseneck trailer. The axle spacing is ok for the trailer as is. I don't think you gave the depth of the frame members, but they probably are plenty strong. If the strength worries you, weld a flat plate on one side of the rails the length of the trailer. 1/8 x 4 inches should be more than enough. Was this a travel trailer or a mobile home? The width between the wheels sounds narrow for a mobile home. The last trailer I made had 6 1/2 feet between the wheels. That barely wide enough for a medium sized tractor. However, you have to go with what you have. Don't forget lights and safety chains if you are going to run it on the road. Hope this helps. KEH
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|