|
Tractor Talk Discussion Board |
Re: Harvester 2424 Industrial
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RW Case on July 27, 2006 at 06:15:05 from (66.83.52.58):
In Reply to: Re: Harvester 2424 Industrial posted by Allan In NE on July 27, 2006 at 06:07:02:
Allan, your picture is exactly what I see - the stop is the problem! On mine the crank is turned so that the bolts are up against the block and I can get enough force to break it loose. Took the strength of 10 Grinches and a short cheater bar to get the first one out! I think that stupid (me) let it set too long and the pistons have a slight rusting to the wall and it wont budge. Is there any way to get it around just a little so I can remove the others? Thanks so much!
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
