Tractor Talk Discussion Board |
Re: Power Steering Problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by souNdguy on August 07, 2006 at 08:01:44 from (12.65.66.81):
In Reply to: Power Steering Problem posted by Paul Lie on August 06, 2006 at 21:04:10:
I'm not familair with your model.. however.. if this were a ford.. I'd have 2 thoughts. 1, depending ont he ps setup.. it is either full ps.. or assist. the assist models have the little cyl alongside the tractor.. and there are not too strong.. even when new.. but they sure beat 'armstrong' steering. the full ps setups vcan get weak pumps, and then they exhibit what you say.. that is.. they only have enough power to steer while moving... Usually this can be 'tested' by revving the engine up and trying to steer. For instance.. rev engine to pto speed and see if it all of a sudden steers fine while setting still. if so.. you were having a volume/pressure issue, and need to look a tthe pump.. especially the filter if it has not been changed in a while... on a ford.. te canister coms off to get at the filter.. not suire baout your beast.. also.. some fluid may be ejected fromt he cap if the filter is plugged.. again.. this is what I observe on fords.. And early fergy and MF used strikingly similar setups.. etc. good luck, and post back. Soundguy
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|