Tractor Talk Discussion Board |
Re: Ampmeter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on August 10, 2006 at 18:02:52 from (66.244.90.5):
In Reply to: Ampmeter posted by Matt Kane on August 10, 2006 at 17:18:09:
Matt, an ammeter is a low impedance pass through current measuring device so it wires in series between the alternators output and the battery. If hooked up right and its good, BOTH terminals should read hot battery voltage with respect to frame ground, as its almost like a short circuit across its 2 terminals. Its Supply side terminal has but one wire attached that gets its voltage from the hot ungrounded battery post, often via where the big battery cable attaches to a starter switch or solenoid. Its other Load terminal is what wires to the alternators main output stud PLUS it feeds battery voltage to loads such as lights and ignition via the BAT input terminals on such switches. On a Negative ground tractor I would expect the ammeters + Supply terminal to wire to the battery/starter and its - Load terminal to wire to the alternator and switches. Reverse that if on a Positive grounded tractor. If you hook it up and turn on lights or ignition tractor not running, it should swing over to - discharge but then when running if charging system works, swing over to + charge. If it does just the opposite no problem, simply reverse its leads. To answer your question YES it probably has like a + and - terminal. Hope this helps, post back any questions, best wishes n God Bless John T
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|