Tractor Talk Discussion Board |
Re: Ampmeter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hal/WA on August 10, 2006 at 21:10:53 from (66.45.175.118):
In Reply to: Ampmeter posted by Matt Kane on August 10, 2006 at 17:18:09:
Be real careful. Lots of ammeters are not designed to handle the amount of amps alternators can put out these days. My son and I put a 60 amp GM alternator on his Scout after the Motorola alternator went bad and we prices a rebuilt Motorola. The way the Scout was wired, it put the total output of the Alternator through the ammeter. We would have been OK if the battery had been fully charged, but it wasn't. After about 10 minutes of running with the new alternator, the ammeter started to smoke. Luckily, my son was in the driveway and we stopped it. It didn't ruin the ammeter, but we probably could have had a dash fire if we hadn't noticed it when we did. The Scout spent the night on the battery charger and my son never let it get discharged again. 60 amps is a fair amount of power. I think the stock alternator was about 30 amps, and even that was probably quite a load for the ammeter. My guess is that your 1 wire alternator puts out a lot more power than what it replaced. Good luck!
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|