Tractor Talk Discussion Board |
Re: O/T language
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jdemaris on September 04, 2006 at 06:16:22 from (66.218.12.121):
In Reply to: O/T language posted by Bratch on September 03, 2006 at 17:52:27:
My opinion for what its worth. Anything . . . can offend somebody, somewhere, sometime. Words, quite often, are just words - and what is more important than the word or phrase is the intent behind it. In regard to what Gene Davis states about profanity being indicative of low-vocabulary - not universally true. Yes, there are some people that seem to know no other way to speak. And, there are others with excellent vocabularies that will utter "Godd*m it" when they bang their knuckles turning a wrench. An intro-course to pyschology will claim that a sane person "style shifts" with language use depending where they are and who with. I.e, a highly educated Ph.D sort of person (if sane) does not spout off with his erudition or pontifications while sitting in a bar-room with a bunch of rednecks. And, to the converse - a person might want to lose his working-class vernacular when in a room full of educated pin-heads. I guess my point is - in this forum of people that I assume are interested in working on old tractors - I don't have to behave much different that when I'm in a shop turning wrenches around other's doing the same. If one was to express offense on the pretext of religious beliefs and Biblical understanding - well? Take Christianity. Seems Jesus expressed concern about fancy churches and shrines - yet they are all over the world? Seems that should be of more concern and a few words uttered with no malice intended. I've known some people in my life that often used "colorful" language that were good, honest, people, and I've met some pretty bad individuals that were Bible-thumping proselytizers.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|