Tractor Talk Discussion Board |
Re: O/T - Briggs Stratton carb problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by landlord7012 on September 22, 2006 at 15:56:32 from (206.40.110.229):
In Reply to: O/T - Briggs Stratton carb problem posted by jCarroll on September 22, 2006 at 15:08:36:
You should have 2 pick-up tubes, one short and one long. The short one draws from a small cup in the tank under the carb. The short one is for start up. It sounds like you are getting enough fuel to start but the long tube is split or blocked with dirt or varnish. Pull the long tube out, squirt some carb cleaner in it and carefully push a straight piece of wire coat hanger thru the tube (not the screen though). Once clean, pressure test it by covering the screen end with your finger and blow into it. If its cracked you'll know right away (if you haven't already seen it). Good luck, ll
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|