Tractor Talk Discussion Board |
Re: pole barn on pilings
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill in NorthCentral Pa on September 28, 2006 at 10:44:40 from (209.50.143.181):
In Reply to: pole barn on pilings posted by Tim, Ohio on September 28, 2006 at 08:52:23:
Questions or points to ponder: 1. With that width, assuming concrete floor and acceptable site, stick framed on a monolithic slab would probably be cheaper / nicer / better. 2. Usually for this type of construction, 29 gauge siding is used. I would investigate a steel "T" bracing for your diagonals. You would install all of your girts and then sawcut a diagonal line across the girts. The "T" fits into this slot and provides an exceptional bracing. The steel barcing provides an enormous amount of bracing when screwed in the flats. I align the sheets and predrill a small hole to keep the screws in line. 3. I'm sure that there is alot more, if you have questions, feel free to contact me. Good luck, Bill
Replies:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|