Tractor Talk Discussion Board |
Re: Grain cleanup
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IaGary on September 30, 2006 at 16:27:18 from (69.63.4.238):
In Reply to: Grain cleanup posted by Dan-IA on September 30, 2006 at 15:51:00:
Dan Are the beans shatting at the sickel? You can tell this by if the beans are under the straw or on top. If they are on top you don't have something set right. First off what is your wind speed.To much wind is better than not enough so that you lift the material across the sieves and not carry the beans out with the straw. How tight is your top seive? Should be about 3/8 to 1/2 inch. I use my finger tips. They should just fit in the opening. Crawl under the combine and look for holes if the beans are just under the width of the cleaning system. Try to narrow it down to where the problem is and we can fix it. How clean is the grain in the hopper? No the only way to pluck the beans off the ground is one at a time with your fingers. Gary
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|