Tractor Talk Discussion Board |
Re: Tractor Wheel Weights
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steve From Arkansas on October 05, 2006 at 18:46:05 from (208.180.47.6):
In Reply to: Tractor Wheel Weights posted by Reverend Brian Jenkins on October 05, 2006 at 16:59:50:
Several years ago when my dads biggest tractor was a 2N I was plowing with a 2 bottom plow. Caught a big root from tree that I was no doubt to close to. The little Ford reared up bent the top link into a U before I could clutch it. I'm not sure just having an emplement on the back will prevent a tractor from going over in every case. I'm sure we had a little larger tire than the tractor came out with. Also a heavier top link would have been nice. Hear in Arkansas I have seen the highway department run a cable from the front of the tractor, I assume it to be attached to the front axil, then it is attached to the drawbar and it hung under the tractor. I understood it was so that if they had to pull each other out of a wet spot, part of the force was place on the front end to keep it down. Has anyone seen this or know why that would not work.
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|