Tractor Talk Discussion Board |
Re: OT Radio antenna (John T)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MarkB_MI on October 09, 2006 at 03:50:00 from (64.31.11.153):
In Reply to: Re: OT Radio antenna (John T) posted by BUDD on October 08, 2006 at 16:53:13:
You have been witholding information! You didn't say this is a automobile radio, let alone that you needed to disable your external antenna so you can receive your XM receiver's FM output. Here is what I think your problem is: A car radio relies on the external antenna, and it uses a shielded cable to cut out interference from various sources in the car. So when you disconnect your antenna, you're attenuating both the broadcast signals and your FM receiver's output. I would try to make up a dedicated antenna for the XM radio. You could make one up from a piece of cable from a car antenna; just strip off the shielding. This antenna would be inside the vehicle, preferably right next to the XM receiver. Ideally, if you can easily get to the back of your FM radio, I would just unplug the exterior antenna and plug in the interior (XM) antenna. You can get short antenna cable extensions to make that easier. Don't use a switch if you can help it; as you've seen they don't work well and will attenuate your signal due to impedance mismatch. Good luck, let us know how it goes.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|