|
Tractor Talk Discussion Board |
electric fence revisited
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmer in the Dells (WI) on October 24, 2006 at 06:45:34 from (66.187.42.39):
Well, the fence is up. Only took time to drive one ten foot galvanized ground rod for trial. Did a final check and turned it on. Only had to wait 5 minutes for test. The critter that usually goes AWOL came to investigate and found out it won't be so easy to go. There is one side of my pasture the runs along side a road where a lot of local people walk. Some of these walkers like to stop, pet, and feed the critters at times. I don't care for the last part since I have no idea what they getting fed. Anyhow, I assume if someone decides to pet the critter that contacts the fence, it may have a dual purpose. Keeping the critters in and the walkers out. I might post signs along that side though. Just in case. The second loop of the pasture is to move them farther off the road during walking season and for rotational grazing. There is no fence at all there so I will rely on a poly tape after they learn and respect the wire. Judging from yesterday, that won't take long. Thanks for all the suggestions. I will probably do what Nathaniel suggested and run the second loop of the "8" off the same controller. I can always switch or disconnect the closer loop to go back to the far loop if need be, and only run one controller.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
