Tractor Talk Discussion Board |
Re: Reason for my electronics 101 question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEB on October 26, 2006 at 08:57:01 from (192.91.171.36):
In Reply to: Reason for my electronics 101 question posted by MMB on October 26, 2006 at 06:36:24:
Hi, while Bob's calculations are correct, assuming the full 6 volts is applied to the field resistor is not. With the resistor in the circuit, the field winding and the external resistor are in series. Assuming 4 amps at 7 volts (roughly the charging voltage) with the field grounded, the resistance of the field winding is about 1.75 ohms. Putting that in series with the 3.3 ohm external resistor gives a field resistance of a little over 5 ohms. At 7 volts and 5 ohms, the current through the series combination of the external resistor and the field winding is about 1.4 amps. 1.4 amps squared x 3.3 ohms gives about 6.5 watts being dissipated in the series resistor. 6.5 watts is pretty consistent with the size of the orignal wire wound resistor. A 10 watt resistor can't dissipate the full 10 watts inside the switch housing (they're rated in free air at a particular temperature) without overheating, but should be able to dissipate 6 or 7 watts just fine. I'd go ahead and use the 10 watt resistor. If you're concnered, go to a slightly higher value, say 5 ohms. Under these same conditions, the current through the resistor would be a shade over an amp, and the resistor would dissipate about 5 watts. Since the output of the generator is directly proportional to the current through the field winding, the output current from the generator would be reduced by about 40% compared to a 3.3 ohm resistor, but should still maintain the battery without any problems. Keith (Electrical Engineer, 30+ years experience)
Replies:
Home
| Forums
Today's Featured Article -
Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|