Tractor Talk Discussion Board |
Re: 6 volt to 12 volt
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on November 01, 2006 at 05:54:12 from (69.178.229.154):
In Reply to: Re: 6 volt to 12 volt posted by John T (Bob n Jim?) on November 01, 2006 at 05:19:22:
JohnT, Using an ignition 'scope to observe the secondary waveform to the 'plugs will confirm that the spark polarity "flips" when the primary connections are swapped. (By convention, traditionally, ignition 'scopes tend to show the spark waveform upside down, to make it easy to observe, or visually measure, the peak firing voltage, which then goes "up", or more (positive) than the baseline, rather than "down", or more negative.) My GUESS is that coils originally manufactured for (+) ground use have the secondary internally connected to the (+) primary terminal, while coils primarily intended for (-) ground use have the secondary internally connected to the (-) terminal. I would say the idea is to have the end of the secondary winding most directly connected to the condensor (when the points are open).
However, in actual use, it doesn't seem to make a noticeable difference in spark. After all, the primary resistance of only a few Ohms is the next thing to a dead short, compared to the 6000 to 7000 Ohms of resistance of the secondary winding that is, in effect, in series with the primary winding, when the breaker points are open. Have you ever thought about the confusion caused when a coil marked "BATT" and "DIST" is swapped, from, say (+) ground to (-) ground? "BATT" becomes "DIST" and "DIST" becomes "BATT". Actually, marking the terminals (+) and (-) sure sounds like the best plan!
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|