|
Tractor Talk Discussion Board |
Re: Buzz Saw
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on November 02, 2006 at 14:51:17 from (66.173.50.165):
In Reply to: Buzz Saw posted by Bill Okrasinski on November 02, 2006 at 10:45:22:
The saw was operated with a single flat belt from the belt pulley of a tractor. The driven pulley was often about 1/2 the diameter of the drive pulley. About 1300-2000RPM I would estimate. There are many tractors that can take a saw well. They require about 15hp or more to run with serious sawing of hard wood. The blades were often 24-30" diameter and basically dangerously unguarded. Google some pictures of saws to get the idea. Making a table, and swing system would not be hard. Mounting it on ball bearings would be the ticket. Guards and safety should be considered!!! The blade may cost more than the other parts conmbined. Good hunting, JimN
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
