Tractor Talk Discussion Board |
Re: Tractor Abuse!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on November 09, 2006 at 07:00:59 from (75.19.125.61):
In Reply to: Tractor Abuse! posted by Allan In NE on November 09, 2006 at 05:13:40:
WOOOOOOOOOO there , just a min . on the abuce thing that rear end is just about the same on all of the 06 seires thru the 86 seires . And i have seen a lowey litttel old 706 gasser eat a rear because of a defective bearing . I had to rebuild the rear end on a 766 gasser from a bad pinion bearing that was a low hour tractor and here again a gasser . And a few years later had the same tractor twist the input shaft off just before going into the T/A, now myself i have never seen that happen before even on the tractors that we sorta made better by our standards and turnen the wicks up and i am not saint when running a pice of equipment as i have TRASHED on lots of stuff , If it would have been a horse it would had whip marks across it's back . Now over the years i have seen more problems on the 1466 and 1486's as to rearend problems . But here i have always thought that this was caused by turning at the headlands with the empelment down and standing hard on the brake and this would work hard on the spiders and side gears and case .Oh i should have said with duals on . Today can't get enough coffee in me and the teylenol is not getting the job done.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|