Tractor Talk Discussion Board |
Re: Hydraulics Questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gerald J. on November 11, 2006 at 09:40:27 from (67.0.97.139):
In Reply to: Re: Hydraulics Questions posted by Allan In NE on November 11, 2006 at 05:45:35:
There are two regulators in your valve. They are independent. The pressure regulator is a shunt regulator, it leaks off excessive pressure. I has no effect on flow until the cylinder is loaded and it takes more pressure to move the load than the pressure regulator is set for. The flow regulator is an orrifice, perhaps with a screw in it that limits flow by adding pressure drop in the hose to the cylinder. Its a series device. 5 gpm moves a 3" cylinder 8" in 5 seconds. Moving that 3x8 cylinder faster usually means banging the piston against the end because the operator can't react fast enough. Heaving a loader from ground to 6' in 10 seconds tends to toss the load or the operator out of the seat as it jerks the tractor around. Sure you can feather the valve if you sandpaper the calouses off your fingers in preparation for safe cracking. With the flow set back to 5 gpm, you can wear ski gloves and still not break things with the hydraulics. You would be best off to reject these single valves without power beyond and go buy a stack valve assembly from Northern, Baum, or Burdens with two sections MADE for single acting, and one section made for double acting. The sections cost the same either way. You NEED the power beyond connections for your single valves so they work like a triple valve otherwise they won't work well. Gerald J.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|