Tractor Talk Discussion Board |
Re: Restoring an old GMC
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JimJoanie on November 12, 2006 at 19:38:15 from (205.188.117.14):
In Reply to: Restoring an old GMC posted by Mobile home mover on November 12, 2006 at 11:32:03:
Wish you had posted a picture, drove a set up like that back in the early 80's while in college pulling a horse trailer over most of the Eastern US. 79 GMS Astro with Cummins and the split 10 speed like yours, and single axle with a sleeper. The original engine was blown earlier and replace with one out of a logging truck in GA. The set up would get up and go. Used to race the flat beds and empty tankers at night. Ah to be young and stupid again.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|