|
Tractor Talk Discussion Board |
Re: Makin' Hay
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by coflyboy on November 18, 2006 at 16:25:23 from (71.34.139.138):
In Reply to: Makin' Hay posted by Allan In NE on November 18, 2006 at 03:42:46:
Allan, now you went and did it. I'm just gonna hafta tell ya.
In the early 40's we had a F-12 Farmall. We pulled a flat bed trailer to the hay field and loaded it by hand with pitch forks. I was around five then so my job was to stomp the hay down on top of the wagon. We then hauled it to the barn, backed it in and hooked the F-12 to a rope which was connected to a block and tackle pulley device. One end of the rope was connected to a single pointed harpon device which was inserted as far as possible into the middle of the hay on the wagon. Attached to the harpon was a handle which extended a barb into the hay at the bottom of the harpon. A rope was attached to the barb handle. When all was set the F-12 pulled the rope through the pulley device. The harpon went up and sideways above the 'hay mow' where at the right moment the barb was tripped and the hay fell into the hay mow.
My job was to tromp down the hay in the hay mow. Since I was just five I didn't always get out of the way when the hay fell. All came to a stop until they dug me out.
On this forum I have not heard the term 'hay mow' or heard described the harpon device that we used. Maybe I didn't recognize the name but would be interested in hearing about the device. Maybe the term 'hay mow' is a Dutch term.
Sorry about the long post but it's Allan fault. He went and posted that picture.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
