Tractor Talk Discussion Board |
Re: OT - Tarm USA add-on wood-fired boiler
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tim B from MA on November 21, 2006 at 11:56:31 from (68.162.218.211):
In Reply to: OT - Tarm USA add-on wood-fired boiler posted by CB in central NY on November 21, 2006 at 09:11:56:
If you have one of the fancy Tarms with the upper secondary combustion chamber (I believe it is intended to add air (oxygen) to the smoke to completely burn the smoke particles) I can't say I have any experience, but I could see that slowing down the flow of smoke out of the boiler and result in what you are experiencing. If so, is there a secondary air inlet to the upper chamber? If you shut that off when the door is open, it may improve flow of smoke to the chimney. I have a similar set-up, but with a very simple boiler (basically two large steel pipes, one inside the other forming the water jacket - with an insulation jacket)not a TARM. The boiler was built with a solid (i.e., not adjastable) baffle at the smoke discharge hole - it was meant to interfere with the draft so the heat does not go up the chimney too fast - I suppose it was supposed to make it more efficient. This baffle caused lots of smoke to come out of the door when loading wood, despite the hinged smoke door hanging down inside the loading door. I dealt with this by just opening the door quick, shoving in a piece of wood, closing it quick, repeat .... It minimized the amount of smoke comming into the basement, but also minimized my pleasure in burning wood. The smoke discharge baffle fell off after a few years (held on by two thin tacked-in-place bolts) and it has been much better since - and I don't think it impacts the efficiency of the boiler at all (not too efficent to begin with). If you have such a baffle, that would be your problem. Would greatly improve if you took it out.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|