Tractor Talk Discussion Board |
Re: Update on Dodge Cummins parts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Davis In SC on December 27, 2006 at 15:20:40 from (152.163.100.74):
In Reply to: Update on Dodge Cummins parts posted by Richard G. on December 27, 2006 at 15:13:49:
There should be some off-the-shelf replacement part that should work, it just has to have an equal or higher amperage reading. I have a 92 Cummins Dodge. There have been several times that it would have been nice to over-ride the manifold heater... Say it is 50 degrees, battery is low (this truck sits a lot) The heater kicks in, & robs the power you need to run the starter.. I have wondered about a manual switch, but it would have to be tied into a thermostat, and you would have to remember to turn it off...
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|