|
Tractor Talk Discussion Board |
Re: Major 4020 ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by msb on December 29, 2006 at 20:37:27 from (71.50.197.176):
In Reply to: Major 4020 ??? posted by Raleigh Boulware on December 29, 2006 at 20:10:14:
That model is dyno checked at 680 PTO RPM (2400 engine RPM)pulled to 620(2200 engine RPM).If you checked it at 540 then it will check low, but it should be higher than 70 hp.Those engines are notorious for slobbering on the right side, but the horsepower reading tells me that you are probably correct about it needing a headgasket.Probably needs a valve grind too.I would not give more than $5500 for it.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
