Tractor Talk Discussion Board |
Re: Major 4020 ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gerald j. on December 29, 2006 at 20:57:09 from (67.0.103.9):
In Reply to: Major 4020 ??? posted by Raleigh Boulware on December 29, 2006 at 20:10:14:
$7400 - 2500 is $4900. A workable price for a gas tractor alone. The 158 is a sturdy and good loader, and often sells for more than $2500. I paid $5250 for a 1968 gas 4020 about 8 years ago. I had to replace plugs and plug wires, and cure its running rich as well as set the timing. If its not been tuned lately too little point gap from rubbing block wear will have retarded the timing and can easily cost 18 hp on the dynomometer. Carbon wires and old plugs can do a lot to reduce the power too. Oil out the side of the head gasket isn't so good. I know mine has been apart, every engine bolt has marks from sockets or box end wrenches. You'd pay several thousand more for a similar vintage diesel and if the Roosa pump hasn't been rebuilt you will soon and that will cost a whole lot more than a few sets of plugs and copper wires. I figured for the price of farm gas when I bought my 4020 gas that if a diesel cost $4000 more, I could pay for gas for 14 years. Since then I have weaned it and the price of gas has gone way up, but I still have years of gas paid for by the savings in purchase price. Doing a head gasket and valve job shouldn't be too expensive. The hood lifts off after you take off the cowl and some bolts and then top of the engine access is very good though not too handy standing on the ground. Some blocks and planks would be handy. Gerald J.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|