Tractor Talk Discussion Board |
Re: barn question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Crem on December 30, 2006 at 15:19:17 from (207.118.236.77):
In Reply to: Re: barn question posted by Gene Dotson on December 30, 2006 at 14:37:13:
I also pulled a lot of loads of loose hay into the hay mow as a kid driving a 9N Ford. When the hay load got up to the top it would trip the carrier so that the load would run down the track inside of the barn and then the guy on the wagon would pull the trip rope to release the load from the forks. Our carrier must have been worn as sometimes when the load got up to the top to the carrier it would trip to roll inside the barn but the catch on the pulley that latched into the carrier would unhook and the whole load would fall back down on the wagon. The guy down there was in trouble if he wasn't standing off to the side.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|