|
Tractor Talk Discussion Board |
Re: BF Avery to fire and run?..$80 in the mail!...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by morgansteven r on February 08, 2007 at 11:32:15 from (216.81.225.103):
In Reply to: Re: BF Avery to fire and run?..$80 in the mail!... posted by MyrlfromPA on February 08, 2007 at 04:22:18:
OK...over lunch I went home and changed the exhaust to .010 and the intake to .008. I also checked the distributor wire connections and adjusted the timing as Myrl instructed. It was sputtering a little as I was turning it over with just the 6 volt on a charger. It only sputtered the first two times I turned it over and then stopped over the next few cranks. I then dripped some ether, and not much, straight in the cylinder and turned it over. IT ACTUALLY, but barly, fired on all cylinders and I had a lot of white smoke but did not really "start". It seems like the timing is close but there is something else wrong. Could I have the wrong spark plugs in it? Maybe the don't produce spark that is "hot" enough? Myrl...I couldn't remember what the .20 was for...is that the distance from the copper peice on the rotor to the points underneath the distributor cap or where the spark is created inside the distributor when the ?arm?peice? breaks contact and creates sparks. Sorry..new to some of this. Thank you for the continued support! Steve
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
