Tractor Talk Discussion Board |
Re: blowing and drifting in central MN
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don Hopf on February 24, 2007 at 18:22:23 from (64.179.163.214):
In Reply to: blowing and drifting in central MN posted by Dave from MN on February 24, 2007 at 16:09:54:
Started snowing at about 2:00PM in Yankton,SD. Rain before that. By 4:30, the snow was about 6 inches deep. Started the 4 wheeler to push the driveway out plus 3 other neighbors driveways. The last driveway was a bear. It snow at least another 3 ins by 6:30. Very wet and heavy snow. This stuff is not going to be blown around by the wind or a snow blower. Previous snows melted this week with the warm weather. Pushed the snow out as far as possible to have room to push snow next time.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|