Tractor Talk Discussion Board |
Re: OT: Horse Fencing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on March 03, 2007 at 04:59:25 from (64.12.116.141):
In Reply to: OT: Horse Fencing posted by John Van Valkenburgh on March 02, 2007 at 20:54:51:
John your fence won't stand very long if only in ground 2 feet. That board you talk about will catch a lot of wind and make fence lean more and more until it ruins your fence. the post need to be a minimum of 3 feet on line post and 3 1/2 to 4 feet for corner,brace and gate post. If you plan on setting post instead of driving I would concrete the corner post. I build a lot of fence in Ky for horse farms and none of them put electric to them. Of course most of them use 4 planks or V mesh horse wire and a board on top. I have had good luck with my Mustang horses and 3 strands of barb wire which most people dont like. They are easier to keep in if they have plenty to eat.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|